Hot take: cutting around heat vents with a utility knife beats any trim tool I have tried
Everybody on the crew swears you need a stair tool and a fresh hook blade to get a clean cut around floor vents, and I used to go along with it. Last month on a 3 bedroom pull in Fresno I was short on blades and the vent cuts kept fraying no matter how slow I went, so out of frustration I tried scoring the carpet from the back with a plain utility knife against a scrap of 1/4 inch plywood. It worked way cleaner than my trim tool ever did, the edges came out straight and I only had to touch up two corners out of nine vents. The trick is not to press hard, just run the blade light along the line about three passes and the backing splits right where you want it. My lead guy watched me do it and said it was a hack that would bite me on Berber, but I did a Berber room after that with the same method and it held up fine. Maybe I am crazy, but has anyone else ditched the trim tool for vent cuts, or am I the only one doing this?