Loading…
14
PSA: Your front panel connectors do not go on the same pins across brands, I learned that the hard way
Spent 90 minutes on my cousin's build last Saturday swapping the power switch and reset headers around because I assumed the layout matched my own board, and the thing just would not post. Turns out the manual has a tiny diagram on page 12 that shows the exact pin order, and once I matched it the rig fired up on the first press. Does anyone else keep a printed copy of their board's layout taped inside the case, or am I the only one who learned this the dumb way?
1 comments
Log in to join the discussion
Log In1 Comment
rose_hart3110d ago
My crowning achievement was spending two hours convinced my board was dead, only to realize I had the power switch plugged into the reset pins the whole time. My cousin just stood there watching me sweat while the actual fix took about four seconds. Now I tape the manual page inside every case I touch, because my memory is apparently useless when it matters. At least we both learned something without frying anything expensive.
5